"sc-250 industries, llc"

Dual Range Lug One 600 MCM - 4 AWG, Two 250 MCM - 1/0 AWG - 1 Count Dual Range Lugs are set screw connectors that will accept either one or two wires. Made of 6061T-6 aluminum alloy. Electro-pin plated for low contact resistance. For use with copper or aluminum conductors. Rated 600 Volts (2000V max. per UL486B). UL 486A/B Listed. Temperature rating 90 degrees C.

Category: 1-Conductor Aluminum Mechanical Lugs

NSI IT-750C 750-250 MCM POLAR

Category: Dual Sided Entry Wire Connector Blocks

250 MCM - 6 AWG Bagged Polaris InsulatedIn-Line SpliceConnector Polaris Insulated In-Line Splice Connectors are suitable for connecting two wires. Abrasion and chemical resistant. UV rated. Will not support combustion. Cold temperature rated to -45 degrees Celsius. Dual rated for use with copper and/or aluminum cables. 600 volts. Not recommended for fine-stranded, flexible wire (see Polaris Grey Series).

Category: ln-Line Splicers/Reducers - Insulated

Polaris™ Insulated Multi-Tap Connector, 8 Port (Dual Sided Entry), 250 MCM - 6 AWG, 600 Volt, Black, Plastisol

Category: Dual Sided Entry Wire Connector Blocks

Polaris™ Insulated Multi-Tap Connector, 5 Port (Dual Side Entry), 250 MCM - 6 AWG, 600 Volt, Black, Plastisol

Category: Dual Sided Entry Wire Connector Blocks

NSI IM16-250-3N-P 16-14 AWG F

Category: Wire Disconnect Adapters

Copper Split Bolt Connector 250 MCM Copper Split Bolt Connectors are high-strength solderless service connectors made of high-copper alloy for copper and copperweld wires. Type for two maximum wire sizes.

Category: Copper Alloy Split Bolts

Interval Timer, 30 Minute, Ivory Twist Knob, 20 Amp, 250 Volt AC, No Hold

Category: In-Wall Spring Wound Time Switches

NPDB LINE 1X-750-250 - LOAD 1X750-250

Category: Single Primary / Single Secondary Non-Insulated Distribution Blocks

POLARIS VISION TAP 250 5 PORT DSE

Category: Dual Sided Entry Wire Connector Blocks

NSI IFL22-250-3N 22-18 AWG IN

Category: Wire Disconnect Adapters

NSI NC-250-0 .250" X 3/8" NYL

Category: Cable Straps

NSI IFL12-250-3N-BULK 12-10 A

Category: Wire Disconnect Adapters

Insulated Multi-Cable Stacked Connector Block, Wire Entry Either Side, 600V, Number of Ports: 6, Wire Range: 6 AWG - 250 MCM, UV Rated, Abrasion and Chemical Resistant. Dual Rated for use with Copper and/or Aluminum Conductors.

Category: Dual Sided Entry Wire Connector Blocks

NSI HTSF12-250-3-P 12-10 AWG

Category: Female Non-Insulated Wire Disconnects

Heavy Duty 1 Cable Parallel Ground Connector for 1/2-3/4in 250 MCM-2/0 AWG. Pipe Made of high-copper-content alloy for grounding to 1/2" - 1" ground rods and ground pipes from 1/4" - 3 1/2" in parallel or 90 degree position. Suitable for direct burial in earth and concrete. Nuts and lockwashers are silicon bronze.

Category: U-Bolt Ground Clamps

NSI HTF12-250-3-S HI TEMP FEM

Category: Female Non-Insulated Wire Disconnects

Long Barrel TinnedCopperSplice250 MCM Long Barrel Tinned CopperSplices is a type of copper compression connector that is produced from high conductivity copper tubing. They are tin-plated to provide corrosion resistance and are marked with die index and color coded for easy reference. Listed for 35KV maximum when properly installed.

Category: Long Barrel Copper Compression Sleeves

.250 Polyester Spiral Wrap

Category: Spiral Wrap - White

4 Wire Polaris 250 MCM-6 AWG Insulated Multi-Cable Connector with Mounting Holes, Either Side Wire Entry Polaris Insulated Multi-Cable Connectors have wire entry ports on both sides of the connector to allow for access from either side. Mounting holes at each end of the connector allow for direct isolated mounting to the trough, panel or wireway. IPLMD Series connectors are insulated with high-dielectric strength plastisol. Molded for precise fit and supplied with removable access plugs over the hex screws. Eliminates the need for cover and taping. Abrasion and chemical resistant. UV resistant. Will not support combustion. Mounting holes will accept a 1/4" bolt for 3/0 AWG and a 5/16" bolt for 250 MCM and 350 MCM. UL Listed 486B Wire Connector. AL9CU. Cold temperature rated to -45 degrees C, rated 600V, 90 degrees C. Dual rated for use with copper and/or aluminum cables. Not recommended for fine-stranded, flexible wire.

Category: Dual Sided Entry Wire Connector Blocks

Insulated Multi-Cable Connector Block, Wire Entry Either Side, 600V, Number of Ports: 10, Wire Range: 250 MCM - 750 MCM, UV Rated, Abrasion and Chemical Resistant. Dual Rated for use with Copper and/or Aluminum Conductors.

Category: Dual Sided Entry Wire Connector Blocks

NSI HTGE-250 2 WAY BASKET 6 S

Category: Transformer Ground Clamps

StandardBarrel TinnedCopperSplice8 AWG Standard Barrel Tinned CopperSplices is a type of copper compression connector that is produced from high conductivity copper tubing. They are tin-plated to provide corrosion resistance and are marked with die index and color coded for easy reference. Listed for 35KV maximum when properly installed.

Category: Standard Barrel Copper Compression Sleeves

NSI 250-3-Z-BULK .250 X .032