Search results

22.5 mm, Non-metallic Pushbutton, Non-Illuminated, Momentary, Flush, Black Operator Button, Black Bezel. NEMA Rating: 1, 3R, 4, 4X, 12, 13. ***Includes: Contact Block Holder***

Category: 22mm Flush Pushbutton Operators

Push-In Type Wire Jumper; 800 Volt; 9 Amp; Insulated; Wire Length: 60 Mm; Conductor Cross Section 0.75 Mm; Black

Category: Terminal Block Jumper Bars

24V Replacement Coil Kit for Definite Purpose Contactors, 600V Rated, 2 & 3-Pole, 15, 25, 30 & 40 Amp, 50/60 Hz, Used with C25 DP Contactor (Series D1).

Category: Starter & Contactor Replacement Coils

MMP Accessory Undervoltage Release, 240V @ 60Hz.

Category: Manual Motor Protector Undervoltage Releases

CR-S012VDC1R INTERFACE RELAY

Category: Signal Converter Interface Relays

Push-In Type Jumper Bar, Insulated, 5-Way, Nominal Current: 32 Amps, Rated Voltage: 800 Volts, Light Gray

Category: Terminal Block Jumper Bars

.25 Ohm Resistor. 90V Motors: 0.5 - 0.8 Hp. 180V Motors: 0.10 - 0.16 Hp. DC Amp: 0.5 - 0.7

Category: Variable Frequency Drive Horsepower Resistors

30 Amp, 600V Rated, Mechanical Hold Down Kit 2-Wire for the C30 Modular Style Lighting Contactor, 120V AC Control Voltage.

Category: Lighting Contactor Mechanical Hold Kits

Mini-Change« B-Size Single-Ended Cordset, 8 Poles, Female (Straight) to Pigtail, STOOW Cable, 3.66m Length

Category: 8-Pin Cordsets

3-Phase 380-500V AC Supply Voltage, Normal Duty: 3 HP 4.8A, Heavy Duty: 2 HP 3.4A, NEMA 1 / IP21, Communications Protocol Ethernet/IP, Wall Mount Drive, Frame Size: R1. H1: 16.11" H2: 14.57" W: 6.1" D: 8.89" Weight: 13.2Lbs, Cabinet Spacing Requirement (7.87 in. Above / 11.81 in. Below), Deratings Required Elevation > 3300ft - Temperature > 104F, Cooling Requirement (26 CFM/ 73W), ** NOT TO BE USED AS A 3-PHASE POWER SUPPLY ** , **Recommend High Speed Fuses Class T Size 10A **, ** Extended Warranty Available w/ Authorized Startup **

Category: 480 Volt AC Operated High Performance Variable Frequency Drives

Modular Led Block - 110-130 V Ac, Integrated Led - Blue - Illuminated

Category: 22mm Base Mount Lamp Blocks

Shield Terminal Block, Rail Mount, 4-Conductor, 5.2 mm Wide, White

Category: 5.2mm Feed Through & Ground Terminal Blocks

Mini-Change« C-Size Double-Ended Cordset, 12 Poles, Female (Straight) to Male (Straight), PVC Cable, 3.66m Length

Category: 12-Pin Cordsets

Mini-Change« B-Size Single-Ended Cordset, 6 Poles, Male (Straight) to Pigtail, STOOW Cable, 6.10m Length

Category: 6-Pin Cordsets

Shaft Coupling, 6 mm, Joins (2) Shafts together for applications where extended length is required.

Category: Disconnect Switch Shaft Adapters & Guides

Sensor Mounting Bracket, Flush, Stainless Steel. For use with Comet Series Sensors.

Category: Sensor Mounting Brackets

22.5 mm, Illuminated, Red, Plastic, Extended, Momentary, Compact Style Pushbutton, 600V Rated. NEMA Rating: 4X, 13. Includes: 1 Normally Closed Contact and 120V AC LED. ***Momentary Pushbuttons are not selectable Maintained verses Momentary in Field***

Category: 22mm Extended Pushbutton Operators

30.5 mm, Heavy-Duty, Sloped Front, Pilot Device Enclosure, Gray, Steel, Surface Mount, 6 Element, 2 Contact Block Depth, NEMA 12, 13.

Category: Steel Pilot Device Enclosures

Abb; Selector Switch; Compact; Amperage Rating: 1 Amp At 220/240 Vac, 1.5 Amp 24/127 Vac, 0.2 Amp At 125 Vdc, 0.3 Amp At 24 Vdc; Action: Spring Return From A Tob; Contact Configuration: 2 No; Actuator: Short Handle; Size: 03 Mr Width X 03 Mr Height X 072 Mr Depth; Enclosure: Ip20; Operating Temperature: -25 To +70 Degc; Function: Three Position Fixed, B And C Return A To B; Bezel Material: Blackplastic; Iit Publishing Status: Level 0 - Information Enabled; Illumination: Non-illuminated; Endurance: Mechanical: 0.5 Million Cycles; Maintained Positions: B, C

Category: 22mm Knob Selector Switches

Blk 4-way Pb Sil-bzl Etched

Category: 22mm Four-Way Pushbutton Operators

22.5 Mm, Non-metallic Heavy-duty - Renewal Part, Led, Flashing, Red, 12 Vdc, Used With 10250T, E34 & E22 Units.

Category: Pilot Lights

30 Amp, 600 Volt, Non-Fused Powerswitch Safety Disconnect Switch in Stainless Steel Enclosure with Factory Installed Auxiliary Contact

Category: Enclosed Non-Fusible Disconnect Switches

WOODHEAD 331020A01F200

Category: 10-Pin Cordsets

Feedthrough Terminal Block End Plate, Fire Load: 0.19 MJ, Gray, Width: 2 Millimeters, Height: 94.5 Millimeters, Depth: 51.7 Millimeters

Category: Terminal Block End Sections